Bohler-Uddeholm Showroom

Visit Bohler-Uddeholm  

 

   Found 4 results for "Bohler-Uddeholm"...

      Just show me: Everything | Articles | News | Products

Article

December 11, 2007
Tooling for forming high-strength material
Editor's Note: This article is adapted from Brett Krause's conference presented at FABTECH® International & AWS Welding Show, Nov. 11-14, 2007, Chicago© 2007 by the Fabricators & Manufacturers Association Intl. (FMA), the... Read more...

Article

August 9, 2005
The science of steel
Tool steel can be produced many ways. The two most common are ingot casting and powder metallurgy (P/M). However, another technology, the spray forming (SF), or Osprey, process, is now commercially available. Figure 1 The general... Read more...

Article

April 6, 2004
Stamping tools for UHSS get tougher
The automotive industry wants to develop cars that are lighter, stronger, and less costly to manufacture. One way it can achieve these goals is to construct body panels, suspension components, structural members, and frames using... Read more...

Article

September 25, 2003
Choosing the proper steel to minimize abrasive adhesive tool wear
Many tools crack because of abrasive or adhesive wear. If one type is mistaken for the other, the actions taken to extend the life of a tool can have the opposite effect. Abrasive Wear Abrasive wear is caused by hard particles, such as carbides... Read more...